Coil Jig is a very handy too that allow you to build your micro coils faster and more efficient. If you are new to build to an experienced veteran, this tool will help you immensely. Getting a tighter wrap is never been easier. The Coil Jig is a great accessory to own if you are a frequent user for RBA / RTA / RDA’s it includes 6 different sized rods: 1.0, 1.5, 2.0, 2.5, 3.0, 3.5mm
Features:
- Sizes: 1.0, 1.5, 2.0, 2.5, 3.0, 3.5mm
- Material: Aluminum Alloy (minor parts may made by non-aluminum alloy)
- Weight: 34 g
What you get:
- 1x Kuro Koiler Concepts 6 in 1
Instructions:
Insert the socket screw into the appropriate hole of the winder section
a. For 26 – 28 gauge wire, use hole number 1
b. For 20 – 24 gauge wire, use hole number 2
Insert wire through hole on the side of the handle. Leave about 1/2″ of the wire protruding from the hole. Hold the end of the wire against the handle so it won’t pull through
Pull the loose end of the wire around the shaft
Slide the winder section over the shaft with the pin facing toward the handle
Turn the winder section so that it catches the wire and starts wrapping it around the shaft. Keep light pressure against handle while winding. Excessive pressure will force smaller gauge wire to wrap over itself
When finished, remove winder and straighten the wire end that protrudes from the hole in the handle
Push up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft